- "Best CFD blog bar none."
"Always a good read."
Another Fine Mesh is "A must for everyone interested in CFD!"
This Week in CFD is "a bit of a mecca for the CFD community."
"Always worth a read by the #HPC and #CFD community."
Tag Archives: Suggar++
From the 2016 Q4 issue of The Connector: Researchers at Pennsylvania State University’s Applied Research Laboratory share an overview of their ongoing work involving overset grid CFD simulations of an incompressible rotorcraft hub they performed using the overset meshing tools … Continue reading
I was born and raised in Innisfail, a small country town in the far north of the state of Queensland, Australia. Being in the far north, Innisfail was hot and humid where the rainfall each year is measured in meters. … Continue reading
Software simulationHub is a new, cloud-based CFD application. Materialise released Magics20 for preparing geometry for 3D printing. CCE released free CAD viewer, EnSuite-View. FFT released Actran 16 with several new features for aeroacoustic simulations. Beta CAE launched v16.1.0 of their … Continue reading
Pointwise Pointwise’s Dr. Steve Karman will participate in a webinar hosted by the Centre for Modeling and Simulation (CFMS) on 21 September to discuss high order CFD technologies. Dr. Peter Vincent from Imperial College London will also participate in the … Continue reading
Celeritas Announces Availability of Suggar++ for Overset Grid Hole Cutting Celeritas Simulation Technology announces the commercial availability of Suggar++, a general purpose overset grid assembly code. Suggar++ can be used as a pre-processor for static configurations or coupled with the … Continue reading
Today’s interview is with Dr. Ralph Noack, a senior Research Associate in the Computational Methods Development Department at the Applied Research Laboratory of The Pennsylvania State University. Ralph and I were coworkers for about three years in the early 1990s … Continue reading